The space station gets a new supercomputer
If all goes well, on August 14, a SpaceX Falcon 9 rocket bearing a Dragon spacecraft will launch for the International Space Station (ISS). On the spacecraft payload is the first commercial off-the-shelf (COTS) high-performance computer to orbit the earth, which just so happens to be among the first supercomputers in space.
Surely, you think, there have been supercomputers in space before? But despite fictional presentations such as 2001’s HAL and the Starship Enterprise's computers, the computer hardware on board spacecraft computers is far from the newest and best around.
The ISS, for example, runs the station using two sets of three Command and Control Multiplexer DeMultiplexer (C&C MDM) computers. One is Russian, the other American. Their processors are 20MHz Intel 80386SX CPUs, right out of 1988.
Other spacecraft, such as the New Horizons spacecraft that recently zoomed by Pluto, is powered by a 12MHz Mongoose-V CPU, based on the MIPS R3000 CPU. You may remember its much faster ancestor: the chip that took you on adventures in the original Sony PlayStation, circa 1994.
Radiation hardening required
Why do spacecraft use such outdated processors? By NASA's rules, not just any computer can go into space. Their components must be radiation hardened, especially the CPUs. Otherwise, they tend to fail due to the effects of ionizing radiation. The customized processors undergo years of design work and then more years of testing before they are certified for spaceflight. For instance, NASA expects its next generation, general-purpose processor, an ARM A53 variant you may know from the Raspberry Pi 3, to be ready-to-run in 2020.
More modern hardware can be found in space; there are laptops on the ISS, 2007-vintage ThinkPad T61p running Debian, Scientific Linux, and Windows 7. They are being replaced by HP ZBook 15s which will run the same mix of Linux distributions and Windows 10. The Linux systems act as remote terminals to C&C MDM, while the Windows systems are used for e-mail, the web, and recreation.
But those laptops are not high-availability, high-performance computers. They're ordinary laptops which are expected to fail. Indeed, there are over a hundred laptops on the ISS and most are defunct.
But for serious data-crunching – the scientific reasons we’re doing experiments on the space station – we want high-performance computing.
HPE contemplated, "Why can't we just use ordinary hardware instead?" After all, most commercial electronics can survive radiation levels in silicon of at least 500 to 1000 rads, which is far more than the ISS endures. And this “Blast off!” is the result.
The traditional way to radiation-harden a spacecraft computer is to add redundancy to its circuits or by using insulating substrates instead of the usual semiconductor wafers on chips. That’s expensive and time consuming. HPE scientists believe that simply slowing down a system in adverse conditions can avoid glitches and keep the computer running.
This year-long experiment’s objective is to achieve a functional supercomputer for operation in space without spending years hardening it, using off-the-shelf servers and custom-built software. Based on this upcoming year-long experiment on the ISS, HPE and NASA are attempting to harden a computer using software by throttling its speed when there's a solar flare or other radiation hazard. If that can be achieved, says Dr. Eng Lim Goh, the mission’s principal investigator and vice president and chief technology officer for SGI, Hewlett Packard Enterprise,“Astronauts will have the latest computers available, increasing their on board capabilities – a factor that becomes essential as they travel further from Earth.”
To find out if this technique works, the ISS supercomputer will be shadowed by an earthbound SGI/HPE twin system in Chippewa Falls, Wisconsin.
Computers going fast: 5 miles per second
The Space Station orbits Earth (and sees a sunrise) once every 92 minutes. Soon it will have a computer that can keep up.
The HPE supercomputer headed to the ISS uses 2-socket “pizza-box” servers from the HPE Apollo 40 family with Broadwell class processors and a high-speed 56 Gigabit per second interconnect. With a speed of over 1 TeraFLOP, while it's not going to give serious competition to the world's fastest supercomputer (China's Sunway TaihuLight), this really is a supercomputer.
In 1997, the first supercomputer to break the 1 TeraFLOP record was ASCI Red at Sandia National Labs. It did so with 7,264 nodes occupying 104 cabinets, and it consumed 850 kilowatts of electricity. The ISS supercomputer will achieve its impressive performance using two nodes on a quarter of a rack with less than a kilowatt of power.
You can't just plug this into the ISS's solar-array-charged 48 volt DC power supply. The computer uses NASA-supplied power inverters to feed it the 110AC the computer needs to work.
Cooling the supercomputer was another obstacle. “Typically, an HPE computer similar to this one would be air-cooled. But for the ISS, HPE created (and the astronauts will be installing) a water-cooled ‘locker’ – not your standard datacenter rack enclosure,” says Dave Petersen, the mission’s co-principal investigator for hardware and SGI’s product design and compliance engineer. However, the rest of the system could be bought from HPE and delivered to your office today. The point is to test ordinary COTS equipment, after all.
So what will really happen? We'll find out.
"We may discover a set of parameters with which a supercomputer can successfully run for at least a year without errors," says Dr. Mark R. Fernandez, the mission’s co-principal investigator for software and SGI's HPC technology officer. "Alternately, one or more components of the system will fail, in which case we will then do the typical failure analysis on Earth. That will let us learn what to change to make the systems more reliable in the future."
If this software method of hardening the system works, Fernandez says, everyone will benefit. Today, when a spacecraft needs high-speed computing power, it must rely on Earth-based computers. For anything close to real-time interactions, that means only low-Earth orbit space vehicles, such as the ISS, can access fast computers. Companies spend years and millions of dollars getting their computer-based projects into space. The use of COTS equipment can revolutionize spaceflight (and science experiments that run in space) by enabling spacecraft to fly with near-current hardware instead of computing gear that's generations behind the state of the art.
Besides gaining the know-how needed to put COTS computers in space, HPE expects to reap other benefits. The software research will help HPE create systems that can deal with harsh conditions. For example, besides spacecraft, computers near nuclear reactors must also deal with radiation issues. Whatever lessons HPE learns can be applied across all its computer lines.
This move is part of a more than 30 years-long relationship between HPE/SGI and NASA. For example, Pleiades, NASA's fastest supercomputer and the 15th fastest in the world, was built by SGI.
The end result? If all goes well, the first manned-flight to Mars will carry powerful HPE COTS computers. We may yet live to see spacecraft with science-fiction computers within their hulls. I hope so.